Installing Red Dot on Sig P229

Ferret33 · May 18, 2018

Hi All

I want to send my Sig P229 9mm to Robert at The Sig Armorer to have the slide milled so that I can install my Trijicon RMR on it. But according to his website, he will only mill the slide if I combine it with one of his action works. So my question for the gurus on this forum is this: of the two action works that he can do on a Legion, which is the one that you think I should get done? Carry Level Trigger job or Carry Level Action job. I am currently using the Sig for home defense but once I move out of Maryland to a state where I can get a carry permit, I will carry the Sig.

Thanks all.

Ferret33

KenBry · May 18, 2018

I think you answered your own question. A super light trigger is not good in a carry gun.

Superzuki · May 18, 2018

I called him a week or so ago. The trigger job is for old German guns, The modern (US made) pistols need his action job. The carry level action job keeps the factory values, but much better and smoother. No target triggers, but good safe trigger action.

lcarlos · May 18, 2018

I agree with Superzuki; when I sent my German Sig P220 to him to have the Sig Carry Level Action Job performed he told me it only needed to have the Trigger Job performed (I was perfectly willing to spend the upcharge for the Action Job but he talked me out of it). I recently sent my Sig P220 SAS to have the Carry Level Action Job and was perfectly happy with the results. I don't believe Mr. Burke will put a sub 3.5# trigger out unless it is intended for range or competition use. The Carry Level Action Job definitely makes for a smoother action.

RLevinson68 · May 18, 2018

No matter what, you can't go wrong with Robert Burke.

loadedround · May 18, 2018

I agree on the action job. He's done two of them for me and I'm 100% satisfied with both.

Ferret33 · May 18, 2018

Thanks guys, the action job it is.

Ferret33

Installing Red Dot on Sig P229

Our Vendors

Top Contributors this Month

Recommended Communities