Was cleaning my long range guns tonight after a desert session. Thought I might as well clean my 229 while as well. It’s my daily carry. Have about 800 rounds though it since new this summer. I do dry fire a lot. It’s a legacy p229. Stripped the slide and noticed the firing pin not as recessed as it should be. Firing pin would not budge. I knew exactly what it was, knocked out the pin and sure enough then outer pin was broken through. Stripped the slide, blew the whole slide out with compressed air and replaced the pin with one out of my other p229 that’s never been fired and ordered two more from midway. It function checks fine, and definelty feels more solid on hammer contact. Check your pins, never had any misfires with it, but will check more regularly now.