SIG Talk banner

1 - 6 of 6 Posts

·
Registered
Joined
·
80 Posts
Discussion Starter #1
When I install the takedown lever on my X5 (tungsten full frame, coyote full frame or carry frame) I have difficulty getting it finally seating. I know about the angle for inserting it past the slide lock and have lubed the O-rings but can’t seem to get it to click into the seated position.

Is there a special sequence to install this easier? I have not found anything online...any guidance/links/tips appreciated.

Thanks in advance for your help.
An X5 Newbie
 

·
Premium Member
Joined
·
1,200 Posts
This might be more helpful to others if it were posted in the P250, P320, & P320 X-5 Pistols sub-forum, plus you'll get more answers to your question.
 

·
Registered
Joined
·
80 Posts
Discussion Starter #4
Just spoke to Sig CS and Custom-shop. They said it will be difficult to insert the takedown lever until the frame & FCU loosens up. There is no special procedure for removing or installing the lever.

If anybody sees/knows of anything different please PM me.

Thanks

Stay safe
P320 Newbie
 

·
Registered
Joined
·
1,292 Posts
It will loosen up over time and use.
 
1 - 6 of 6 Posts
Top