SIG Talk banner

1 - 3 of 3 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter · #1 ·
I want to upgrade to red dot optics, and see that the procut slide offers that ability with a simple bolt on.
Will this part fit my p226 extreme CA compliant?


I have a loaded chamber indicator. Will the new slide just cover that up and not make it work? I don’t mind, but I don’t want any problems.

can I just buy these parts and have them shipped to my house? Any laws against shipping this slide and a mag to my house instead of to an FFL?
Any laws that prevent me from modifying my Sig with this slide and the romeo1pro?

will this fit?

Thank you!
Also, do you recommend the shroud for the romeo1pro?
 

·
Resident Armorer Premium Member
Joined
·
11,598 Posts
All Sig Sauer P226 slides will interchange. As far as your LCI, the above photo doesn't show the pro-cut slide having the LCI cut, so essentially you will have a "slot" at the rear of your chamber, that could allow you to "see" the base of a chambered round. The slot is low enough on the casing, where the brass is thicker, so case rupture shouldn't be a problem. Of course you could always install a non-LCI barrel too, to eliminate the slot. The fewer paths for combustion gases to reach your optics leads to cleaner lenses!
 
  • Like
Reactions: SigSourNoob
1 - 3 of 3 Posts
Top