SIG Talk banner

1 - 3 of 3 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
Has anyone installed the Strike Industries MPX brace on the Copperhead?

https://www.strikeindustries.com/si-stab-mpx-mcx.html

The lower receiver on the Copperhead is slightly different, with the 2 guide holes in the rear to accommodate the rail bars of the extendable brace. The strike brace installs onto the rear picatinny rail. I am wondering if everything lines up correctly, and if Strike's rail bars will fit into the lower receivers guide holes....
 

·
Registered
Joined
·
31 Posts
Has anyone installed the Strike Industries MPX brace on the Copperhead?



https://www.strikeindustries.com/si-stab-mpx-mcx.html



The lower receiver on the Copperhead is slightly different, with the 2 guide holes in the rear to accommodate the rail bars of the extendable brace. The strike brace installs onto the rear picatinny rail. I am wondering if everything lines up correctly, and if Strike's rail bars will fit into the lower receivers guide holes....
I haven't, but I had the Strike Industries brace on my MPX, and returned it after using it once - the rail paint transferred onto my hands when handling it, and onto my cheek when shooting. Strike's response was basically "that's normal." Pretty disappointing since the brace itself is a nifty design and the overall package was pretty lightweight.
 
1 - 3 of 3 Posts
Top