SigTalk is a forum community dedicated to SIG Sauer enthusiasts. Come join the discussion about Sig Sauer pistols and rifles, optics, hunting, gunsmithing, styles, reviews, accessories, classifieds, and more!

Problems with safety disconnect reassembly

615 Views 5 Replies 3 Participants Last post by dtrinski, 12 mo ago

dtrinski

Discussion Starter · 12 mo ago

I am trying to install the MCarbo spring set and ran into a problem with reassembly. The safety disconnect doesn't seem to fit in the cut on the FCU as seen in the installation videos I've watched. It is not seating correctly (see pictures). Any suggestions?
Thanks

See less See more

Save

1 - 6 of 6 Posts

DEL107

· #2 · 12 mo ago

Slide it in from the bottom.

Save

jerrym

· #3 · 12 mo ago

You don't have it in the grooves. Drop the trigger bar, reinstall the disconnect by sliding it into the slot from the bottom. Relocate the trigger bar and install the trigger spring.

Save

dtrinski

Discussion Starter · #4 · 12 mo ago

jerrym said:
You don't have it in the grooves. Drop the trigger bar, reinstall the disconnect by sliding it into the slot from the bottom. Relocate the trigger bar and install the trigger spring.

Duh....that was easy. So now I can't get the slide to go back on completely. It gets hung up about 1/4" from the end of the frame.....

Save

jerrym

· #5 · 12 mo ago

sent you a message

Save

dtrinski

Discussion Starter · #6 · 12 mo ago

jerrym said:
sent you a message

Double Duh... Watched videos on slide reassembly. Problems solved! Thanks to you two for responding to my questions. Now, I need to get to the range.

Save

Reactions: 1

1 - 6 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Problems with safety disconnect reassembly

dtrinski

Attachments

DEL107

jerrym

dtrinski

jerrym

dtrinski

Top Contributors this Month