SIG Talk banner
1 - 11 of 11 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Are there any instructions or videos showing how to replace the take down lever and slide catch on the P365 SAS with those that come one the standard P365?
 

·
Registered
Joined
·
332 Posts
Yeah, those recessed controls are a solution to a problem no one had. I assume the reason people don't complain about them more is because they are too busy complaining about how bad the sights are.

The best thing about COVID - was easy to sell mine.
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #7 ·
Yeah, those recessed controls are a solution to a problem no one had. I assume the reason people don't complain about them more is because they are too busy complaining about how bad the sights are.

The best thing about COVID - was easy to sell mine.
I had mine checked and they were off with no way to adjust them. Put a red dot on it and moved on.
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #8 ·
I looked there too, but no soap. :(
 

·
Registered
Joined
·
1,311 Posts
Yeah, those recessed controls are a solution to a problem no one had. I assume the reason people don't complain about them more is because they are too busy complaining about how bad the sights are.

The best thing about COVID - was easy to sell mine.
My sights are fine but I did just get it a couple months ago. I have heard early models had problems being way off.

Sent from my SM-X700 using Tapatalk
 
1 - 11 of 11 Posts
Top