SIG Talk banner

P250 SC 380 Take Down lever

741 Views 6 Replies 4 Participants Last post by  SIG51
I have a rather unique problem with my takedown lever; it backs out horizontally while has never fully disengaged from the grip module as I have halted my shoots and re-set the take down

this happens regardless of the gain size ammo I'm shooting and it is rather unnerving to see this happen.:eek:

The SIG Rep I spoke with this morning said this was a 'first' and I will be sending the gun to them for analysis.

Guess I will know in 3 weeks or so what was found and of course will post the findings/fix
1 - 1 of 1 Posts

· Registered
617 Posts
Doesn't the o ring keep it from turning on it's own, but the keyway keeps it in place horizontally until turned?

I just realized this is about a 250, so maybe it's different than the 320?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.