SIG Talk banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I am interested in installing the Superlative Arms adjustable gas block (https://suparms.com/collections/adj...ock-stainless-steel-finish?variant=5710957381) to my M400 Tread rifle (16" barrel). I know the barrel is 0.750" but I am not sure this will fit where the factory gas block is located. Anyone have any experience replacing the gas block with an adjustable gas block? Any chance anyone has experience with this specific adjustable gas block install?

Thank you in advance for any help.
 

·
Registered
Joined
·
385 Posts
Looks like the fourth picture shows the measurements, so you should be able to measure the inside of your handguard to see if there's enough room to fit, if nobody is able to get you an answer.


Sent from my iPhone using Tapatalk
 
1 - 3 of 3 Posts
Top