SIG Talk banner

41 - 41 of 41 Posts

·
Registered
Joined
·
265 Posts
My P365X slide arrived today. Was able to easily remove the the optic plate using the 2 mm hex head bit from my Craftsman bit set. Had my soldering iron on the ready but each mounting screw came loose with a little effort and steady/firm downward pressure. The 2 mm bit fit perfectly with no slop. Tried the 5/64 hex bit but the fit felt a little sloppy.

Mounted my Holosun HS407K X2 on the new P365X slide and torqued the mounting screws to 15 inch pounds with my Utica TS35 driver and a Torx T10 bit.

Was suprized the P365X slide had no recoil posts protruding at the front of the slide optic cutout to mate with the circle cuts at the front of the underside of the Holosun sight. Anyone else surprised by the lack of recoil posts?

Now to get this setup sighted in at the range.
 
41 - 41 of 41 Posts
Top