SIG Talk banner
  • Notice image

    SigTalk is a forum community dedicated to SIG Sauer enthusiasts. Come join the discussion about Sig Sauer pistols and rifles, optics, hunting, gunsmithing, styles, reviews, accessories, classifieds, and more!

hello from europe

667 Views 19 Replies 20 Participants Last post by  PVK
kind of new here on the sig board
living and located in europe, just want to check and find out what parts from what models are hard to find in the usa
altough i am aware that several models that been brought out in europe, never were introduced and sold in the USA

hope to hear from you, best regards, john
1 - 20 of 20 Posts
Welcome to ST.

Many SIG models share parts--especially frame parts. Most parts aren't too hard to find. Extractors and firing pins for older folded steel slides can be sometimes difficult to find. Magazines in .38 Super are super rare.

It's really the discontinued models that you might have difficulty find parts for.
  • Like
Reactions: 1
Welcome from CA (Central Alabama) -- enjoy your tour.
Welcome from Alabama......
Seems like I've been over there somewhere- Amsterdam or Rotterdam.....not sure, long ago- was a cadet on the S/S Adabelle Lykes back in 1968. Gosh that was over 50 years ago. Guess I'm getting old :oops:
Welcome to the forum from Las Vegas, NV
Welcome from Georgia.
kind of new here on the sig board
living and located in europe, just want to check and find out what parts from what models are hard to find in the usa
altough i am aware that several models that been brought out in europe, never were introduced and sold in the USA

hope to hear from you, best regards, john
Welcome from Texas.
Sig 551 parts are hard to get. Send a shipping container full of them over.
Welcome to SigTalk from the flatlands of Kansas.
Greetings from Texas and welcome to the forum!
Greetings from Georgia.
Welcome from PA...
Vriendelijke groet vanuit Belgie !
1 - 20 of 20 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top