SIG Talk banner

Armory Craft flat trigger installed!

2727 Views 14 Replies 9 Participants Last post by  Wulfmann
Installed my adjustable flat trigger from armory craft and man is this trigger awesome!

Almost no pretravel and the reset is short and crisp!
1 - 15 of 15 Posts

· Registered
Joined
·
491 Posts
Installed my adjustable flat trigger from armory craft and man is this trigger awesome!

Almost no pretravel and the reset is short and crisp!

Nice looking set up.
Its good to hear a good report on this trigger.
I have two on pre-order. I am told will be shipped Monday March 27.
Can't wait !!!!
 

· Registered
Joined
·
527 Posts

· Registered
Joined
·
527 Posts

· Registered
Joined
·
3,852 Posts
My trigger arrived today.

The Delrin pretravel elimination pin was a pain.
In my new M11A-1 I had to remove almost every bit of the Delrin to activate the DA which required a lot of trial and error because while you can remove more if needed you can't put any Delrin back.
This comes like this because there are many variations in how it might fit various Sigs so you have to file it down or in my case I used a razor to slice off pieces

Great feel to this trigger a big improvement over the standard one when new but my 4-5 year old M11A-1 with the broken in trigger is about as nice.

That is not a slam because it means you can skip a lot of break in with this flat trigger and go right to sweet
 
1 - 15 of 15 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top