SIG Talk banner

1 - 4 of 4 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
Hey all

This is my first sigtalk post. I just bought my second 365. Born on date 9/2/20. My first 365 was born in Nov 2019. My first sig runs like a champ. Zero issues. I bought another one to have one dedicated EDC 365 and one dedicated trainer. Anyhow on my new 365 I noticed that the rear of the slide is not flush with the frame rails. On my first sig the slide is perfectly flush. On this new 365 the rear frame rails stick out past the rear of the slide. It looks pretty sloppy and I should have noticed it at the LGS before I bought it. I called sig customer service and they said to email the pictures and they would advise. So far no response. Anyone else have a 365 that looks like this? I realize these aren’t hand fitted guns but it doesn’t look good. I’m sure it will run just fine. I haven’t shot it yet due to no 9mm ammo in my area.
 

Attachments

·
Registered
Joined
·
5,737 Posts
Btw, my very first P365 so far has over a thousand rounds without a single malfunction. It looks just like that.
 
1 - 4 of 4 Posts
Top