SIG Talk banner
1 - 6 of 6 Posts

Registered
Joined
899 Posts
Discussion Starter · #1 ·
OK, so new gun, cleaned and lubed per Sig video before firing. 4 mags, all well and good. Then new mag would not seat. Tried 4 different mags, both loaded and empty. Doesn't matter whether the slide is locked back or not. With gun upside down and mag release pressed mag will drop into place but will not lock.

Any experience with this? Thanks much.
 

Registered
Joined
899 Posts
Discussion Starter · #3 ·
Oops, this was operator error, not a Sig issue. Grabbed a .357 SC mag, so obviously too short to lock up. Embarrassing enough, but glad I didn't send it in :>). All mags now marked C or SC. SIG should actually mark the mags more visibly as to caliber, though as well as F, C, SC.
 

Resident Armorer Premium Member
Joined
14,304 Posts
Everyone makes mistakes... you had the courage to admit it... too many don't!!!
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top