sig 716

New 716 Tread shoots great! However, it comes with a typical crappy Sig charging handle, so I bought a Radian Raptor AR10/SR25 and it will not work. When properly installed with bolt and in all the way it binds and will not move until you finger the bolt and remove it first - then charging...

Hey, I was wondering if the 716G2 Patrol version offered for Military/LE clients is select-fire capable or not? There's surprisingly little information regarding that on the SIG official site (or maybe I'm just bad at looking for it). Thanks in advance!

I recently purchased a 716 Patrol brand new. I filled the mag with ammo and pulled the charging handle to load one into the chamber, I pulled the trigger, and "click".... So I attempted to pull the charging handle back to clear the chamber and I cannot pull it back. It's like the gun froze up...

I decided to take the rest of the ZQI ammo that bought a few weeks ago to work on the 716 and see if I can come up with any solutions for the folks that are having problems with theirs. Mine works with hand loads, but has not had great success with factory ammo. I looked in the chamber and...

Hello all, new to these forums and a new owner of a SIG 716 as well. I have a question about the 716 gas valve. I've searched everywhere and haven't found an answer. The manual states that the valve should freely turn between normal and adverse, but that the detent has to be pressed to...

Hi just shot my brand new 716, 60 rounds fired every time ok , but on the bottom of each shell casing a small chunk of metal is scraped off and right behind where the shell ejects on the frame it's gouging off the metal on the gun frame , is this normal.? Used PMC Bronze Line Rifle Ammunition...

www.youtube.com/watch?v=pJC2HIp3ew4" This is my new 716 Patrol rifle that was just sent back to SIG for feeding/accuracy problem. I received it back today. Despite the detailed letter I sent along with the rifle describing the problem and asking that they not just polish the feed ramps and ship...

Hey Everyone, Just picked up my Sig 716 in OD Green and I have question or two at point did Sig stop putting the bayonet lug on the bottom of the gas block I know it’s a mute feature for a bayonet but I was going use it for a bipod mount and keep the quad rail clean so does anyone know if I can...

i've seen this question asked a few times and the common response is in addition to the magpul prs stock to get a full length rifle tube, 308 buffer and 308 buffer spring from brownells or midway. sounds simple but it wont cycle. i believe the bolt carrier on the sig 716 is longer than that of a...

Almost new black Sig716 Only 40 rounds through it, then put away. No modifications done or issues. Car issues forcing sale $2400 plus actual ffl and shipping fees Comes with 1 magpul mag. No APO,FPO or states with with restrictions. Email if interested, I can email pics.

Is it normal for a Sig 716 to be denting brass at the edge like this? Almost every round is like this out of 40 rounds fired. Sent from my iPhone using Tapatalk

So from your experience, what has been the most accurate factory loaded ammo that you have shot out of your SIG 716? What was the MOA at 100 yards?

Hey guys, I just picked up a Sig 716 and still have about $1,000 to spend on a decent optic. I'm looking at the Eotech HHS-II and the Trijicon SRS. I'm leaning towards the Eotech for the magnifier part of it but the Trijicon has it's benefits too. I guess I can't go wrong with either but with...

SIG 716 Flat Dark Earth (see below) And here come the long guns! Well...some of them aren't so long, as Sig is really increasing their availability of short-barreled versions of their most popular rifles. In fact, there are so many variations that a full picture catalog would be overwhelming...