I've heard that .380 rounds loaded with the Lehigh designed bullet are prone to jam if used in the P238. Underwood and Lehigh are the two manufactures which I know of. I like the ballistics tests I see when it is fired from other .380 pistols, but I don't want to toss about $40 bucks away...

I was wondering if anybody can help me. Purchased a Equinox P238. Only has 50 rounds through it. Yesterday while shooting I had a soft primer hit. It was the ammunition. After ejecting the shell (which was tough) I went to load a new magazine. When I turned the pistol on its side, the mainspring...

I have fired exactly 48 rounds through my new P238 Rainbow after I picked it up at the local gun range. I noticed what looks like a crack in the slide while cleaning it. Is it just the finish, or do I need to send it back to Sig for a new slide? Anyone else have this problem?

I just joined today for a couple of specific reasons: I need help with what i think may be a cracked slide on my new P238. 48 rounds so far without a problem, but sad, I know. I'm also seeking opinions on both the P239 and P226. I think I found a source for a P226 without rails which interest...

Never had a problem after 500 rounds. I clean my P238 and now a jam every 2-3 rounds. Jam occurs on feed only. No problem ejecting spent cartridges. Cartridge never gets chambered or leaves magazine and slide remains locked back. Have used the same range amo with no issues in past. Ejector...

brand new 27a 238,problems from the third magazine on. 3 different sig mags,remington federal and blaser rnfmj ammo..... failure to feed problems...cleaned 3 times during the 205 rounds...ftf at least 30... last 5 rounds were zombies, by then what the heck...2 ftf. the first mag girlfriend loved...